Hardiplank Removal Instructions Step by Step For Gresham Residents

Gresham Hardiplank Siding ContractorsFor Hardiplank Removal instructions first know that HardiePlank is a trademarked product by the James Hardie Company.

A company located in the Golden State with workplaces and procedures around the world.

HardiePlank is applied as lap siding and even installed over a water-resistant barrier product using a blind-nailing or screw-in technique.

Even periodically a face-nailing method for really high wind applications.

HardiePlank comes in a vast array of shades, surface appearances, board widths as well as trim pieces as well as is created for long-term use of Thirty Years or more.

Extraction alternatives vary somewhat based upon setup strategy.

Also whether you are eliminating one or a few pieces of siding for substitute or demoing the siding from the framework entirely.

Hardiplank Removal Instructions Video

Hardiplank Removal Instruction Steps

Glide the thin edge of a flat lever meticulously under the reduced side of the initial piece of HardiePlank siding to be gotten rid of.

Utilize a mallet or hammer to gently drive the tip of bench up behind the siding if essential.

Pry the item of siding out towards you carefully to let you see the nail or screw pattern of how the slabs have been attached to the under-structure.

Place the level bar under the very first nail or screw and also slap the free end of bench with a mallet or hammer to displace the nail or screw.

Repeat along the first slab to eliminate it totally, subjecting the nails or screw bolts on the next board down.

Remove screws for partial demolition projects with a drill fitted with screwdriver bit (operating in reverse), which will certainly limit damage to the under-structure.

This process may not be practical for massive elimination of HardiePlank where the pry bar technique could be a lot more effective.

Hardiplank Resources

Further study and training can be found here. Learn more about Hardiplank in general here.